Airdrop Extended [Unmaintained]

Airdrop Extended | Page 27 | Oxide

 

Hey, can you help me find solution for this please,

the plugin works great but there are two problems:

1- I edit the capacity of the airdrop to 18 but its still 6 when its landed . ("Capacity": 18,)

2- Nothing display in the side chat when I loot the airdrop , only it appears in console . ( "NotifyOnLootEntityingStarted": True, )
......

I appreciate your efforts to help others, Thank you

 

What file did you edit and in what folder and did you do it with the commands in the overview

 

I edit AirdropExtended.json

and you can see the location of the file in the picture.
i just edit these commands:

("Capacity": 18,)

( "NotifyOnLootEntityingStarted": True, )

,,

 

Try using the rcon command its faster and does it correctly or edit file in data folder

 

will try it , Thank you Resistance

 

i found that after each wipe the settings would sometimes not work , so i enter the commands listed in the "front page" into the clanforge console to set drop times/amounts/contents etc and it works fine, I find that setting the container limit to 18 it a little too much (and i had problems with it resetting to default), and that 16 is the best max amount, if you have a max (as i do) of four containers and an airdrop every 70 minutes it is quite sufficient..
you will know you have entered the correct information as a confirmation message will appear and also list the next available drop,
A great plugin

 

I have one problem, all airdrop, drop package outside of the map, in water.

 

Check your drop Location in your settings

 

Yes, i know, but i dont know how configure that :/

 

Airdrop Extended | Page 27 | Oxide

 

I am using this plugin, But no matter how much i change the airdrop speed, whether its 1 or 100000, it always stays the same speed

 

Check the overview and use the rcon commands to do it

 

I keep trying to change the data file for it but it constantly wipes it back to the default settings. Here is what I am trying to put, far as I could tell it was all valid.

 

Are you using rcon commands to edit the settings or you just editing the file

 

The file, is there a reason I shouldnt be using the file?

 

best to use the rcon commands to edit the settings

 

Could we get some help on this please?

 

Got it! everything is great, Except i do not know which way increases airdrop speed, 40 is defualt, do I increase or decrease to make the airdrop faster?

 

increase